Carefully push all 8 unstrapped colored wires into the connector. Step 3: A straight cut across the 8 wires to shorten them to 1/2 Inch (1.3 cm) from the cut sleeve to the end of the wires by crimping tool. This configuration allows for longer wire runs. Note how the green pair is not side-by-side as are all the other pairs. It is highly recommend you duplicate the color order as shown on the left. STRAIGHT THROUGH Ethernet cables are the standard cable used for almost all purposes, and are often called “patch cables”. There is two kinds of Ethernet cable is used for communication. Each pin is identified by a number, starting from left to right, with the clip facing away from you. Introduction: There are four pairs of wires in an Ethernet cable, and an Ethernet connector (8P8C) has eight pin slots. Ethernet Cable – Category 5e or CAT5e or CAT6.It is used to download the any modification and which is made in graphics in engineering station.RJ45 cable also used for communicate the printer with computer. RJ45 cable is used for connect the ALL HMI and engineer station through a switch to communicated each other.
0 Comments
Leave a Reply. |